90 degree Corner Centre T for 60mm Galvanised Pipe Verandah Bracket Its fixing holes are suitable

Its fixing holes are suitable for a wide range of common mechanical and chemical masonry anchors

the tube cannot pass through the bottom of the fitting

this fitting can reduce the need for cutting on horizontal rails

the fitting remaining cast in place

Leaving it unfinished

90 degree Corner Centre T for 60mm Galvanised Pipe Verandah Bracket Its fixing holes are suitableWhere would you normally use this galvanised pipe fitting? The 116 is a 90 degree corner joint, often used on middle rail on level sites and often paired with type 128. This fitting cannot be used where through tube (vertical in photo) has to be joined within the fitting. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 60mm. What is it made out of? All of the pipe fittings are