Straight Connector for 42mm Galvanised Pipe Round Wrought Iron Baluster for use with matching rivet

for use with matching rivet nuts

A 16x16mm black wrought iron baluster with two adjustable knuckle

Drill the end of the handrail (with a 16mm drill bit)

which will suit any of our fully round handrails from 40mm to 60mm in diameter

it can be trimmed back to 37 degree to form part of the handrail on a staircase when needing to change from the horizontal plane to a 37 degree incline (most stairs are pitched at 37 degrees)

Straight Connector for 42mm Galvanised Pipe Round Wrought Iron Baluster for use with matching rivetWhere would you normally use this galvanised pipe fitting? The 167M Double Swivel Male Part is a double lugged fitting. The tube cannot be joined within the fitting. Warning: To provide sufficient stability, whole structures must not be made from swivel fittings alone. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 42mm. What is it made out of? All of the pipe fittings are made