Sloping Elbow (0-11 degrees) for 42mm Galvanised Pipe Verandah Post Its fixing holes are suitable

Its fixing holes are suitable for a wide range of common mechanical and chemical masonry anchors

often used to join staircase top rail to upright at top end of staircase

A water based primer/undercoat is not a necessity (although it wouldn’t hurt)

Plantation grown European Beech that has been H3 treated (suitable for above ground use)

but this is now no longer the case

Sloping Elbow (0-11 degrees) for 42mm Galvanised Pipe Verandah Post Its fixing holes are suitableWhere would you normally use this galvanised pipe fitting? The 154 Slope Elbow is an angle joint adjustable for slopes from 0 degree to 11 degree, normally used where top rail meets end upright on sloping sites. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 42mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to