E4-3S manual slow or your feed wheel

slow or your feed wheel spins but the tape doesn't dispense

Electric Cutter & Yoke Kit

Heater Socket

The other end of the keypad is plugged into the Controller Board  (E1-4CB) and all communication takes place

Keypad can be found only on our discontinued model Phoenix E1

E4-3S manual slow or your feed wheelHeater Socket This socket is mounted to the outside of the frame next to the Motor Cover (E1 3). The heater is plugged directly into this socket. It rarely needs to be replaced, only if it gets cracked or an excessive build up of dust. It would be better to replace the entire assembly of the Male Harness (E1 4MHX)